Table of Contents
Advertisement
Good Read Delay
This sets the minimum amount of time before the scanner can read another bar code. Default = 0 ms (No Delay).
* No Delay
Medium Delay (1,000 ms)
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code below, then set the delay (from 0 - 30,000 mil-
liseconds) by scanning digits from the inside back cover, then scanning Save.
Manual Trigger Modes
When in manual trigger mode, the scanner scans until a bar code is read, or until the trigger is released. Two modes are avail-
able, Normal and Enhanced. Normal mode offers good scan speed and the longest working ranges (depth of field).
Enhanced mode will give you the highest possible scan speed but slightly less range than Normal mode. Enhanced mode is
best used when you require a very fast scan speed and don't require a long working range. Default = Manual Trigger-Normal.
* Manual Trigger - Normal
Serial Trigger Mode
You can activate the scanner either by pressing the trigger, or using a serial trigger command (see
9-3). When in serial mode, the scanner scans until a bar code has been read or until the deactivate command is sent. The
scanner can also be set to turn itself off after a specified time has elapsed (see
User-Specified Good Read Delay
Short Delay (500 ms)
Long Delay (1,500 ms)
Manual Trigger - Enhanced
Trigger Commands
Read
Time-Out, which follows).
on page
3 - 5
Advertisement
Table of Contents
