Good Read Delay; User-Specified Good Read Delay - Honeywell Xenon XP 195 Series User Manual

to an error. To change the number of error beeps, scan the barcode below and then
scan a digit (1-9) barcode from the
then Save. Default = 1.

Good Read Delay

This sets the minimum amount of time before the scanner can read another
barcode. Default = 0 ms (No Delay).

User-Specified Good Read Delay

If you want to set your own length for the good read delay, scan the barcode below,
then set the delay (from 0 - 30,000 milliseconds) by scanning digits from the
Programming Chart,
86
* No Delay
Medium Delay (1,000 ms)
beginning on page 311, then Save.
Programming Chart,
Number of Error Beeps/LED Flashes
User-Specified Good Read Delay
beginning on page 311,
Short Delay (500 ms)
Long Delay (1,500 ms)
Xenon XP User Guide