Installation With A Seat Facing Opposite To Direction Of Travel - Otto Bock Kimba Neo Instructions For Use Manual

1 T2 respirator platform
2 T1 respirator platform
3 Retaining bracket with mounting materials

6.2.1 Installation with a seat facing opposite to direction of travel

Installing the T2 respirator platform
1) Glue the loop strap onto the centre of the front frame tube (see fig. 18).
INFORMATION: Trim the length to approx. 210 mm for size 1 and approx. 290 mm for size 2.
2) As shown in the image, glue the hook strap onto the angle tabs of the T2 respirator platform (see fig. 19).
3) Set the T2 respirator platform onto the front frame tube and axle tube (see fig. 20).
4) Lift up the T2 respirator platform on the axle tube. Under the angle tabs, glue 2x loop strap in the size
50 x 50 mm onto the axle tube (see fig. 21).
5) Press the T2 respirator platform into place.
→ The T2 respirator platform is installed (see fig. 20).
18
20
Installing the T1 respirator platform
1) As shown in the image, glue the hook strap onto the angle tabs of the T1 respirator platform (see fig. 19).
2) Screw the retaining bracket onto the T1 respirator platform (see fig. 22, item 1; see fig. 23, item 1).
3) Screw the supports onto the retaining bracket (see fig. 22, item 2).
INFORMATION: Only installing one support on the retaining bracket initially is recommended. The
second support is installed on the retaining bracket when the T1 respirator platform is mounted on
the front frame.
4) Set the T1 respirator platform onto the front frame tube (see fig. 24, item 1).
5) Engage the supports of the T1 respirator platform in the lashing points and install (see fig. 25; see fig. 24
item 2).
→ The T1 respirator platform is installed (see fig. 24).
Kimba Neo, Kimba Cross, Kimba Inline
4 Bottom supports (with mounting materials)
5 Hook-and-loop straps
6 Side supports (with mounting materials)
19
21
Preparation for use
Ottobock | 21