Securing The User In The Product - Otto Bock Kimba Neo Instructions For Use Manual

1) In the direction of travel, slide the product approximately in the middle between or over the perforated rails
anchored on the bottom of the vehicle and secure it with the wheel lock.
2) Check that the belt system in the vehicle matches the lashing points installed on the product.
3) Attach the tie-down straps mounted on the bottom of the vehicle to the lashing points on the product (see
fig. 60; front: item 1, rear: item 2):
→ Front: engage the hooks in the lashing points from the inside to the outside (see fig. 69, item 1).
→ Rear: engage the hooks in the lashing points from the inside or the outside (see fig. 70, item 1).
4) Firmly tighten the tie-down straps in accordance with the manufacturer's specifications. The maximum angle of
the front tie-down-straps is 45° (see fig. 71).
5) Fold the push handle down to provide additional stability for the seating system (see fig. 71, item 1).
6) For "swivelling" front wheel option only: turn the caster wheels to face forwards for improved stability (see
fig. 71).
7) Remove all prohibited components from the product (Permitted Use).
8) Adjust the suspension to "firm" (Adjusting the suspension).
→ The tie-down straps are correctly attached (see fig. 71).
69
71

7.2.7.8 Securing the user in the product

For transportation in a vehicle for transporting persons with reduced mobility, the user must be secured in the
rehab buggy with safety belts as follows:
1) Place the user in a nearly upright seated position.
2) Attach the lap belt to the anchor points (pins) provided:
→ Pull one end of the lap belt from each side of the seat through to the bottom (see fig. 72, see fig. 73).
→ Engage the ends of the lap belt on the anchor points (pins) provided (see fig. 74, item 1).
→ INFORMATION: The lap belt must be worn at an angle of 45° to 75° to the horizontal. When this is
not possible in exceptional cases, an angle between 30° and 45° to the horizontal can also be
chosen (see fig. 75).
3) Engage the shoulder belt in the lap belt (see fig. 76).
Kimba Neo, Kimba Cross, Kimba Inline
70
72
Use
Ottobock | 37