Adjusting The Wheelbase; Disassembly And Transport - Otto Bock Kimba Neo Instructions For Use Manual

Use
2) Screw in the adjustment screw (see fig. 103, item 2) until the scraping noise at the rear wheel disappears and
the wheel runs freely.
3) Tighten the counter nut (see fig. 103, item 1) until the adjustment screw is fixed.
→ The braking force of both rear wheels must be adjusted equally.
103

7.4.5 Adjusting the wheelbase

1) Loosen the clamping wheels on both sides (see fig. 104).
2) Press the two buttons on both sides simultaneously (see fig. 104, item 1).
3) Increase or decrease the wheelbase.
4) Tighten the clamping wheels (see fig. 104).
104

7.4.6 Disassembly and transport

CAUTION
Exposed pinch points
Crushing, pinching due to incorrect handling
► When folding out the backrest, only grip by the specified components.
NOTICE
Deformation when folded
Damage to the product, problems unfolding due to unallowable loads
► Never place heavy objects on the folded product.
INFORMATION
The product can be equipped with the Kimba Neo seating unit or alternative seating systems. In this case, please
observe the information in the separate instructions for use for the seating system.
1) Pull up the lock slides on both sides and fold the push bar forward (see fig. 105).
2) Lay the push bar onto the frame (see fig. 106 and see fig. 107).
48 | Ottobock Kimba Neo, Kimba Cross, Kimba Inline