Adjusting The Wheelbase; Use As A Bicycle Trailer; Mounting The Coupling On The Bicycle - Otto Bock Kimba Neo Instructions For Use Manual

82

7.3.6 Adjusting the wheelbase

1) Remove the two Allen screws on both sides of the oval tube front frame.
2) Push in or pull out the front frame to adjust it in the range of 800 mm to 920 mm (see fig. 83 and see fig. 84).
3) Reposition and tighten the two Allen screws of the oval tube front frame on both sides.
83

7.3.7 Use as a bicycle trailer

CAUTION
Risky operation
Falling, tipping over backwards and to the side due to approaching obstacles incorrectly
► Test the driving behaviour of the linked bicycle and bicycle trailer in a safe environment before taking trips.
► Test the wider wheel track in a safe environment.
► By looking ahead while riding, avoid driving over larger obstacles quickly with just one rear wheel.
► Never cross obstacles at an angle. Always approach obstacles head on (at an angle of 90°).
► Avoid drifting when driving through curves.

7.3.7.1 Mounting the coupling on the bicycle

The scope of delivery includes:
• Coupling, type E from the Weber company for mounting to the axle of a bicycle
• Two metal locking disks for bicycle hubs with rigid axle (large hole) or with quick-release mechanism (small
hole)
1) Remove the wheel nut or quick-release mechanism.
2) Slide the basis onto the axle (see fig. 85, item 4).
3) Insert the locking disk so that the joint piece is horizontal (see fig. 85, item 3 and item 2).
INFORMATION: Make sure that the teeth of the locking disk properly engage with the basis.
4) Firmly tighten axle and coupling with the wheel nut or quick-release mechanism.
5) Check if the wheel is seated securely.
6) Position the safety cable around the wheel axle and engage it (see fig. 85, item 1).
Kimba Neo, Kimba Cross, Kimba Inline
84
Use
Ottobock | 41