Wheel Lock; Engaging The Wheel Lock; Adjusting The Wheel Lock - Otto Bock Kimba Neo Instructions For Use Manual

100

7.4.4 Wheel lock

CAUTION
Wheel lock not engaged when getting in or out
Falling, tipping over of the user due to user error
► Before the user gets in or out, always engage and check the wheel lock.
► Engage the wheel lock to prevent the rehab buggy from moving on uneven ground or during transfers (e.g.
into a car).
NOTICE
Incorrect use of the wheel lock
Damage to wheels, loss of braking function due to incorrect operation
► Do not use the wheel lock whilst travelling. The product must be standing still before braking.
► Do not engage the wheel lock forcefully.
► When you activate the wheel lock and feel clear resistance, you can move the wheels slightly forwards or
backwards to change their positions so that the lock pin latches on to the brake ring.

7.4.4.1 Engaging the wheel lock

1) Pull the wheel lock levers to apply the drum brakes (see fig. 101). Optional: By simultaneously moving the
small wheel lock levers down, lock the wheel locks (see fig. 102).
2) Activate the wheel lock levers again to release the wheel locks (see fig. 101).
101

7.4.4.2 Adjusting the wheel lock

To achieve an optimum braking effect, the braking force is adjusted using the adjustment screw (see fig. 103, item
2).
Increase the braking force: Back off the adjusting screw.
•
Reduce the braking force: Screw in the adjustment screw.
•
1) Loosen the counter nut (see fig. 103, item 1) and back off the adjustment screw until a scraping noise can be
heard when the rear wheel is rotated.
Kimba Neo, Kimba Cross, Kimba Inline
102
Use
Ottobock | 47