Cleaning - Otto Bock Kimba Neo Instructions For Use Manual

Use
108

7.5.3 Cleaning

Cleaning by hand
1) Clean all frame components and plastic parts using mild detergents only.
2) Wash covers made of spacer fabric and microfibre at a maximum temperature of 40 °C. To do this, remove the
covers from the padding and wash the covers only.
INFORMATION: You can wash covers in the washing machine – but only in a laundry bag or pillow
case. However, wiping with a damp cloth is sufficient in most cases.
Important information on cleaning
• Do not use any aggressive cleaners, solvents or hard brushes, etc.
• Dirty springs should be cleaned with a soft, dry brush to prevent wear.
Cleaning in a washing chamber (Kimba Neo only)
1) Remove the padding and covers, and follow the washing instructions for each article.
2) Wash the rehab buggy at max. 60 °C for max. 10 minutes.
3) If necessary: Remove all components where water has accumulated.
4) Allow the rehab buggy to dry. In order to do so, set the folded rehab buggy vertically onto the back wheels and
push handles so that water can run out (see fig. 109).
INFORMATION: We recommend drying with compressed air.
5) If necessary: Reinstall all components that were removed.
6) Before storing or using the rehab buggy again, verify that it is dry. Wipe wet components with a damp cloth as
needed.
7) Ensure that all labels (nameplate and warnings) are still legible. Otherwise replace these labels.
109
50 | Ottobock Kimba Neo, Kimba Cross, Kimba Inline