Mitsubishi Electric FR-D720-0.2K-G Instruction Manual page 220

Parameter
Name
Number
Output interruption
577
cancel level
C42 PID display bias
(934) 
coefficient
C43 PID display bias
(934) 
analog value
PID display gain
C44
(935) 
coefficient
PID display gain
C45
(935) 
analog value
The above parameters can be set when Pr. 160 Extended function display selection = "0". (Refer to page 161.)

Pr. 129, Pr. 130, Pr. 133 and Pr. 134 can be set during operation. These can also be set independently of the operation mode.

The value left of the slash is for the 2.2K drive unit or lower. The one right of the slash is for the 3.7K drive unit.

If a value exceeding the upper speed limit of the motor is set, the actual operation will be limited at the maximum rotation speed. The setting range is for the
S-PM motor. The maximum setting value differs depending on the number of poles of the applied motor.

If C42 (Pr. 934) and C44 (Pr. 935) are both set to values other than "9999", the setting range for Pr. 131 to Pr. 133 and Pr. 553 become only "9999", and % is
not displayed in the setting range of Pr. 577. (Values set in Pr. 553 and Pr. 577 are converted as differentials.)

The parameter number in parentheses is the one for use with the parameter unit (FR-PU07).
Special operation and speed control
Initial Setting
Value Range
1000% 900 to 1100%
Set the level (Pr. 577 minus 1000%) at which the PID output
 
interruption function is canceled.
0 to 500.00 Set the coefficient on bias (minimum) side of terminal 4 input.
9999
9999 Displayed in %.
Set the converted % on bias (minimum) side current /voltage of
20% 0 to 300.0%
terminal 4 input.
0 to 500.00 Set the coefficient on gain (maximum) side of the terminal 4 input.
9999
9999 Displayed in %.
Set the converted % on gain (maximum) side of current/voltage of
100% 0 to 300.0%
terminal 4 input.
Description
4
217