12.45
Removing the engine guard
12.46
Installing the engine guard
–
Inject the liquid into the system until it escapes from open-
A
ing
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws
bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
F01218-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
Remove screws
–
Lower the engine guard at the rear and remove it toward the
front.
E00964-10
–
Position the engine guard on the frame at the front and mount
1
screws
but do not tighten yet.
–
Position the engine guard on the frame at the rear and mount
and tighten screws
Guideline
Screw, engine guard
–
Tighten screws
Guideline
E00964-10
Screw, engine guard
SERVICE WORK ON THE CHASSIS 12
4 mm (0.16 in)
1
and
2
.
2
.
M6x20
10 Nm (7.4 lbf ft)
1
.
M6x12
10 Nm (7.4 lbf ft)
83