12.47
Removing the engine guard (All special models, 350 XW‑F US)
12.48
Installing the engine guard (All special models, 350 XW‑F US)
–
Now inject fluid into the system until it escapes from the
6
openings
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Remove the bleeding syringe. Mount and tighten the bleeder
screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
E00339-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
–
Remove screws
H01638-10
–
Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
H01638-10
SERVICE WORK ON THE CHASSIS 12
of the master cylinder without bubbles.
4 mm (0.16 in)
1
and engine guard.
1
.
M6
10 Nm (7.4 lbf ft)
93