Checking The Engine Oil Level; Changing The Engine Oil And Oil - KTM Freeride 250 F 2018 Owner's Manual

18.2

Checking the engine oil level

18.3 Changing the engine oil and oil filter, cleaning the oil screen
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Drain the engine oil while the engine is at operating temperature.
Finishing work
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use an effective exhaust extraction system when
starting or running the engine in an enclosed
space.
–
Start the engine and check the response.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Condition
The engine is at operating temperature.
–
Check the engine oil level.
Info
After switching off the engine, wait one minute
before checking the level.
The engine oil is at a level between the lower edge
E00989-10
and the middle
»
If the engine oil is not up to the lower edge
level viewer:
–
Add engine oil. (
Preparatory work
–
Park the motorcycle on a level surface.
–
Remove the engine guard. (
SERVICE WORK ON THE ENGINE 18
B
of the level viewer.
p. 126)
p. 83)
A
A
of the
123