Removing The Engine Guard (Exc-Fsix Days Us); Installing The Engine Guard (Exc-Fsix Days Us) - KTM 500 EXC-F 2023 Owner's Manual

12.47 Removing the engine guard (EXC-F SIX DAYS US)
12.48 Installing the engine guard (EXC-F SIX DAYS US)
–
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove the protection cap,
remove bleeder screw
K01342-10
–
Now inject fluid into the system until it escapes from the
6
opening of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Remove the bleeding syringe. Mount and tighten the bleeder
screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
E01224-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Immediately clean up any brake fluid that has over-
flowed or spilled with water.
–
Remove screws
H01638-10
–
Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
H01638-10
SERVICE WORK ON THE CHASSIS 12
4
with the appropriate hydraulic fluid.
p. 156)
5
and mount bleeding syringe
4 mm (0.16 in)
1
and engine guard.
1
.
M6 10 Nm (7.4 lbf ft)
4
.
95