12.12
Adjusting the play of the steering head bearing
12.13
Greasing the steering head bearing
12.14
Removing front fender
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Pull out hose
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
F01210-10
to avoid strains.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top
steering stem
–
1
Insert hose
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
H02387-01
Preparatory work
–
Remove the headlight mask with the headlight. (
SERVICE WORK ON THE CHASSIS 12
1
from the front steering head screw.
2
3
. Remove screw
.
4
.
M20x1.5
12 Nm (8.9 lbf ft)
2
.
M8
22 Nm (16.2 lbf ft)
3
.
M8
17 Nm (12.5 lbf ft)
into the steering head screw.
p. 60)
(
p. 57)
(
p. 58)
p. 53)
Loctite
®
243™
p. 53)
p. 106)
61