Selecting An Operating Mode - Siemens SONOLINE G50 Instructions For Use Manual

5 B e g i n n i n g a n E x a m i n a t i o n

Selecting an Operating Mode

When powered on, the system automatically displays in 2D-mode. You can
change modes by pressing the appropriate control or key located on the
control panel. Selection of A-mode, full-screen M sweeps, and full-screen
spectral Doppler waveforms is accomplished using LCD selections.
Use the system presets to display the 2D image simultaneously with the
M-mode sweep or Doppler spectrum when M-mode or Doppler is selected.
If you do not activate the bypass cursor display selection in the system
presets, the system displays the 2D image with the cursor when M-mode or
Doppler is selected and you must select the control a second time to display
the sweep or spectrum.
Mode
A-mode
2D-mode
Split (B+B) mode
Dual-mode
4B-mode
2D/M-mode
Split 2D/M-mode
M-mode
Doppler
Steerable Continuous
1
Wave Doppler
Auxiliary Continuous
2
Wave Doppler
Color
Power
Directional Power
Doppler
1
Available with the SONOLINE G60 S system; requires the Cardiac Imaging option for the
SONOLINE G50 system
2
Available for the SONOLINE G60 S system only
5 - 1 8
Selection
Press the 2D control on the control panel, push the PAGE control on the LCD panel
to display LCD page 2, and then press the
Press the 2D control on the control panel.
Press the SPLIT key on the control panel.
Press the left or right DUAL/SELECT key on the control panel. A 2D image displays in
the respective half of the image area. Press the other DUAL/SELECT key to display
an image in the other half of the display area. The last DUAL/SELECT key pressed
(left or right) establishes the active image. Press either key twice to display the image
full-screen. Return to dual displays by pressing the key once again.
(Requires software version 1.2 or higher)
Press the 4B key on the control panel.
Press the M control on the control panel two times while in 2D-mode.
Press the SPLIT key on the control panel and then press the M control.
Press the M control on the control panel two times and then press the
selection to On to display full-screen M-mode.
Press the D control on the control panel two times.
To display full-screen Doppler, press the
An update function is available to toggle a frozen 2D image with a real-time spectrum
or a real-time 2D image with a frozen spectrum. During 2D-mode with M/D-mode,
the M-mode sweep is synchronized with the Doppler spectrum.
Connect a phased array transducer to an array port and then press the CW key.
Connect a continuous wave (pencil) transducer to the CW port and then press the
CW key.
During 2D-mode, 2D/M-mode, or 2D with Doppler, press the C control.
During 2D-mode, 2D with Doppler, or 2D with Color, press the POWER key.
Use the Dir Power Power LCD selection to aid in determining power flow relative
to the transducer. Press
A-mode LCD selection.
Full D LCD selection.
Dir Power until the required setting displays on the LCD.
[ 1 ]
F4
Default Settings
Bypass M/D
Cursor Display
Full M LCD
I N S T R U C T I O N S F O R U S E