Tabs - Siemens SONOLINE G50 Instructions For Use Manual

Changing a Setting of an LCD Selection
If multiple settings for a highlighted selection are available, rotate the
SELECT-L control or SELECT-R control to change a setting.
For example, during 2D imaging, the LCD includes a selection for dynamic
range (DR). To adjust the dynamic range, you must first press the key
adjacent to the selection. The system highlights the setting for the dynamic
range. Then, you have two choices to adjust the setting:
Repeatedly press the
Rotate the SELECT-L control.
To change a setting of an LCD selection located on the right side of
the LCD:
Repeatedly press the selected LCD control, or rotate the
SELECT-R control.
To change a setting of an LCD selection located on the left side of
the LCD:
Repeatedly press the selected LCD control, or rotate the
SELECT-L control.

Tabs

When you activate a mode or function, the system displays LCD selections
for that mode or function. The system also assigns a tab for the selections
at the bottom of the LCD. To access LCD selections for an active mode or
function, rotate the FUNCTION SELECT control. The system highlights the
active tab.
[ 1 ] I N S T R U C T I O N S
DR key, or
F O R U S E
3 S y s t e m C o n t r o l s
3 - 3 3