Charging The Battery; First Time Battery Charge - Motorola HC700-G User Manual

Charging the Battery

The battery is charged when the HC700-G is docked in cradle. A fully charged battery provides 10
hours of typical usage or 24 hours in Standby mode. The charging status of the spare battery is
indicated by the Spare battery Status LED.
• When not in use, always place the HC700-G in a powered cradle. Leaving the HC700-
!
G out of the cradle may drain the battery, causing memory lost from RAM
• To avoid battery damage, the battery must never be allowed to remain totally drained
Caution
for over a period of one week
Always use Motorola HC700-G original batteries and battery chargers. The HC700-G warranty does
not cover damage caused by using non-Motorola batteries and/or battery chargers.
The following sections describe the installation and charging of the battery of the HC700-G.

First Time Battery Charge

New batteries are shipped partially charged. Charge the battery before using the HC700-G for the first
time.
Insert the battery, bottom end first, into the battery compartment.
1.
Carefully, press the battery top downward until it clicks and locks in place.
2.
Place the HC700-G inside the cradle - the Status LED inside the Power button shows steady red.
3.
Charge the battery until the status LED shows steady green.
The HC700-G cradle charges the battery most effectively when it is at room temperature [approx. 68°F
(20°C)]. The ambient temperature range during battery charging should be 32°F to 95°F (0
56
Using the HC700-G
C to 35 C).
° °