Table of Contents
Advertisement
Attaching the Hand-strap
The HC700-G has an adjustable hand-strap which enables to hold the unit for extended periods and
provide ease of use. The strap is made of flexible material with Velcro
To attach the hand-strap to the back of the HC700-G, perform the following:
Turn over the HC700-G to view the back side and insert the U shaped clip of the hand-strap into the
1.
notches on the imager housing (see Figure 9).
Attach the buckle end of the strap through the cavity located next to cradle interface connector.
2.
To adjust the handstrap: release the Velcro patches and adjust the length of the strap. The strap can
3.
be extended in a range of 4.9 to 7.4 inches.
18
Starting to Work
Attaching the hand-strap
FIGURE 9.
2
1
®
attachment patches.
Advertisement
Table of Contents
