Ipv4 Lan Settings (Ata 192 Only) - Cisco ATA 191 Administration Manual

Analog telephone adapter guide for multiplatform firmware
Hide thumbs Also See for ATA 191:
Table of Contents

Advertisement

IPv4 LAN Settings (ATA 192 Only)

Table 8: Optional Settings
Field
DNS Server Order
Allow Auto Configuration.
Primary DNS
Secondary DNS
IPv4 LAN Settings (ATA 192 Only)
Use the Network Setup > Basic Setup > IPv4 LAN Settings page to set the IP address and subnet mask for
your local network. Also configure the settings for the built-in DHCP server (ATA 192 only).
After making changes, click Submit to save your settings, or click Cancel to redisplay the page with the
saved settings.
Router IP
Enter the Local IP Address and Subnet Mask for your local network. The default setting is 192.168.15.1
with a subnet mask of 255.255.255.0.
DHCP Server Setting
Field
DHCP Server
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
20
Description
Choose the preferred method for choosing a DNS
server.
• DHCP-Manual—The DNS server settings from
the network server takes precedence, and your
entries in the DNS fields are used only as a
backup.
• Manual-DHCP—Your entries in the DNS fields
take precedence, and the DNS server settings
from the network server are used as a backup.
• Manual—Your entries in the DNS fields are
used to choose a DNS server.
Enable if you want to allow Auto Configuration.
Set the Primary DNS for IPv6.
Set the Secondary DNS for IPv6.
Description
The ATA can use the built-in DHCP server to
dynamically assign IP addresses to connected devices.
Click Enabled to enable the DHCP server, or
clickDisabled to disable this feature.
Default setting: Enable
Network Configuration

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ata 192

Table of Contents