Cisco Ata 191 And Ata 192 Analog Telephone Adapter Administration Guide For Multiplatform Firmware - Cisco ATA 191 Administration Manual

Vertical Service Activation Codes
Field
Feature Dial Services Codes.

Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware

68
Description
These codes let the ATA know what to do when you are listening to
the first or second dial tone.
One or more *codes can be configured into this parameter, such as *72,
or *72|*74|*67|*82, and so on. The maximum length is 79 characters.
This parameter applies when you have a dial tone (first or second dial
tone).
After receiving dial tone, you enters the *code and the target number
according to current dial plan. For example, after you dial *72, the ATA
plays a special tone called a Prompt tone while awaiting you to enter a
valid target number. When a complete number is entered, the ATA
sends a INVITE to *72 target_number as in a normal call. This feature
allows the proxy to process features like call forward (*72) or Block
Caller ID (*67).
The *codes should not conflict with any of the other vertical service
codes internally processed by the ATA. You can remove a corresponding
*code that you do not want to the ATA to process.
You can add a parameter to indicate which tone plays after the *code
is entered, such as *72'c'|*67'p'. Below is a list of allowed tone
parameters (note the use of open quotes surrounding the parameter,
without spaces).
'c' = <Cfwd Dial Tone>
'd' = <Dial Tone>
'm' = <MWI Dial Tone>
'o' = <Outside Dial Tone>
'p' = <Prompt Dial Tone>
's' = <Second Dial Tone>
'x' = No tones are placed, x is any digit not used above.
If no tone parameter is specified, the ATA plays Prompt tone by default.
If the *code is not to be followed by a phone number, such as *73 to
cancel call forwarding, do not include this parameter. Instead, add the
*code in the dial plan and the ATA send INVITE *73@..... as usual
when you dial *73.
Default setting: blank
Voice Settings Configuration