Cisco Ata 191 And Ata 192 Analog Telephone Adapter Administration Guide For Multiplatform Firmware - Cisco ATA 191 Administration Manual

Voice Settings Configuration
Field
Block ANC
DND
CID Setting
CWCID Setting
Dist Ring
Secure Call Setting
Message Waiting
Accept Media Loopback Request
Description
Setting Block Anonymous Calls on or off.
Default setting: no
Setting DND on or off.
Default setting: no
Caller ID Generation on or off.
Default setting: yes
Call Waiting Caller ID Generation on or off.
Default setting: yes
Setting Distinctive Ring on or off.
Default setting: yes
If yes, all outbound calls are secure calls by default, without requiring
the user to dial a star code first.
Default setting: no
Note
Setting this value to yes can activate stutter tone and VMWI signal.
This parameter is stored in long term memory and will survive after
reboot or power cycle.
Default setting: no
Controls how to handle incoming requests for loopback operation.
Default setting: Automatic

Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware

• If Secure Call Setting is set to yes, all outbound calls are secure.
However, a user can disable security for a call by dialing *19
before dialing the target number.
• If Secure Call Setting is set to No, the user can make a secure
outbound call by dialing *18 before dialing the target number.
• A user cannot force inbound calls to be secure or not secure; that
depends on whether the caller has security enabled or not.
This setting is applicable only if Secure Call Serv is set to yes
on the line interface. See
1 and PHONE 2), on page
• never—Never accepts loopback calls; replies 486 to the caller.
• automatic—Automatically accepts the call without ringing.
• manual—Rings the phone first, and the call must be picked up
manually before loopback starts.
Supplementary Service Settings
Line 1 and Line 2 Settings (PHONE
35.
91