Event Log Setting - Cisco ATA 191 Administration Manual

Administration Settings
Table 74: Debug Log Settings
Field
Download Log
Clear Log
Filter

Event Log Setting

Use the Administration > Log > Event Log Setting page to collect required event logs. Event log messages
are sent via SYSLOG protocol using UDP transport type.
Use the Event Log Setting when troubleshooting. Four event categories are defined:
• DEV—Device information. A message is sent once device boot-up and network connectivity are ready.
• SYS—System-related information. A message is sent once while device boot-up and network connectivity
• CFG—Status of provision and configuration file change. A message is sent every time the provision
• REG—Registration status for each line. A message is sent every time registration status changes.
Enter the settings as described below. After making changes, click Submit to save your settings, or click
Cancel to redisplay the page with the saved settings.
Table 75: Event Log Settings
Field
Address
Port
Flag
are ready.
service restarts due to configuration or network status change.
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
Description
Click this button to download the contents of the log as a file on your
computer. In the dialog box, you can open the file or save it. The file
can be opened in a text editor such as Notepad.
Click this button to remove all entries from the log.
Enter a keyword to filter the log entries that appear in the viewer. The
page will display only the entries that include the keyword.
Description
Set the Event log server address.
Set the Event log server port.
Default value: 514
Set the Event log flag, it's a bitwise value. Setting list is as below:
<Dev>:1(0x01)
•
<SYS>:2(0x01<<1)
•
• <CFG>:4(0x01<<2)
• <REG>:8(0x01<<3)
Default value: 15 (All events)
Event Log Setting
103