Advanced Settings; Port Setting (Ata 192 Only) - Cisco ATA 191 Administration Manual

Network Configuration
Field
Time Server Address.
Resync Timer
Auto Recovery After Reboot

Advanced Settings

Use the Network Setup > Advanced Settings pages to configure features including port flow control, MAC
address cloning, VPN passthrough, and VLAN.

Port Setting (ATA 192 Only)

Use the Network Setup > Advanced Settings > Port Setting page to set the ETHERNET (LAN) port
attributes.
After making changes, click Submit to save your settings, or click Cancel to redisplay the page with the
saved settings.
Table 12: Port Settings
Field
Flow Control
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
Description
To use the ATA's default Network Time Protocol
(NTP) server, select Auto from the drop-down list. If
you want to specify the NTP server, select Manual,
and then enter the NTP server address.
Default setting: Auto
Enter the Resync timer interval value (in seconds).
This timer controls how often the ATA resynchronizes
with the NTP server.
Default setting: 3600 seconds
Choose this option to allow the ATA to automatically
reconnect to the time server after a system reboot.
Default setting: Disabled
Description
Flow control is a mechanism that temporarily stops
the transmission of data on a port. For example, a
device is transmitting data faster than some other part
of the network can accept it. The overwhelmed
network element halts the transmission of the sender
for a specified time.
Choose Enabled to enable this feature, or choose
Disabled to disable this feature.
Default setting: Enabled
Advanced Settings
25