Firmware Upgrade - Cisco ATA 191 Administration Manual

Firmware Upgrade

Field
Log Resync Failure Msg:
Report Rule:
Firmware Upgrade
Table 34: Firmware Upgrade Settings
Field
Upgrade Enable.
Upgrade Error Retry Delay.
Downgrade Rev Limit.
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
52
Voice Settings Configuration
Description
Syslog message issued after a failed resync attempt.
Default setting: $PN $MAC -- Resync failed: $ERR
The target URL to which configuration reports are
sent. This parameter has the same syntax as the
Profile_Rule parameter, and resolves to a TCP/IP
command with an associated URL.
A configuration report is generated in response to an
authenticated SIP NOTIFY message, with Event:
report. The report is an XML file containing the name
and value of all the device parameters.
This parameter may optionally contain an encryption
key. For example:
[ --key $K ] tftp://ps.callhome.net/$MA/rep.xml.enc
Default setting: blank
Description
Determines if the firmware upgrade operations occur
independently of resync actions.
Default setting: yes
The upgrade retry interval (in seconds) applied if there
is an upgrade failure. The ATA has a firmware
upgrade error timer that activates after a failed
firmware upgrade attempt. The timer is initialized
with the value in this parameter. The next firmware
upgrade attempt occurs when this timer counts down
to zero.
Default setting: 3600
Enforces a lower limit on the acceptable version
number during a firmware upgrade or downgrade.
The ATA does not complete a firmware upgrade
operation unless the firmware version is greater than
or equal to this parameter.
Default setting: blank