Cisco Ata 191 And Ata 192 Analog Telephone Adapter Administration Guide For Multiplatform Firmware - Cisco ATA 191 Administration Manual

Analog telephone adapter guide for multiplatform firmware
Hide thumbs Also See for ATA 191:
Table of Contents

Advertisement

Voice Settings Configuration
Field
Busy Tone
Reorder Tone
Off Hook Warning Tone
Ring Back Tone
Ring Back 2 Tone
Confirm Tone
SIT1 Tone
SIT2 Tone
SIT3 Tone
Description
Played when a 486 RSC is received for an outbound call.
Default setting: 480@-19,620@-19;10(.5/.5/1+2)
Played when an outbound call has failed, or after the far end hangs up
during an established call. Reorder Tone is played automatically when
Dial Tone or any of its alternatives times out.
Default setting: 480@-19,620@-19;10(.25/.25/1+2)
Played when the caller has not properly placed the handset on the cradle.
Off Hook Warning Tone is played when the Reorder Tone times out.
Default setting: 480@-10,620@0;10(.125/.125/1+2)
Played during an outbound call when the far end is ringing.
Default setting: 440@-19,480@-19;*(2/4/1+2)
Your ATA plays this tone instead of Ring Back Tone if the called party
replies with a SIP 182 response without SDP to its outbound INVITE
request.
Default setting: the same as Ring Back Tone, except the cadence is 1s
on and 1s off.
Default setting: 440@-19,480@-19;*(1/1/1+2)
Brief tone to notify you that the last input value has been accepted.
Default setting: 600@-16;1(.25/.25/1)
Alternative to the Reorder Tone played when an error occurs as a caller
makes an outbound call. The RSC to trigger this tone is configurable
on the SIP screen.
Default setting:
985@-16,1428@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0)
Alternative to the Reorder Tone played when an error occurs as a caller
makes an outbound call. The RSC to trigger this tone is configurable
on the SIP screen.
Default setting:
914@-16,1371@-16,1777@-16;20(.274/0/1,.274/0/2,.380/0/3,0/4/0)
Alternative to the Reorder Tone played when an error occurs as a caller
makes an outbound call. The RSC to trigger this tone is configurable
on the SIP screen.
Default setting:
914@-16,1371@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0)

Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware

Call Progress Tones
57

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ata 192

Table of Contents