Network Settings For The Lan And Dhcp Server (Spa122 Only) - Cisco SPA112 Administration Manual

Configuring the Network
Basic Setup
Cisco SPA100 Series Phone Adapters Administration Guide
Network Settings for the LAN and DHCP Server (SPA122
Only)
Use the Network Setup > Basic Setup > Network Settings page to set the IP
address and subnet mask for your local network. Also configure the settings for
the built-in DHCP server.
To open this page: Click Network Setup in the menu bar, and then click Basic
Setup > Network Settings in the navigation tree.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to abandon any unsaved entries.
Router IP
Enter the IP address and subnet mask for your local network. The default setting is
192. 1 68. 1 5. 1 /24.
DHCP Server Setting
Field
DHCP Server
Description
The ATA can use the built-in DHCP server to dynamically
assign IP addresses to connected devices. Click
Enabled to enable the DHCP server, or click Disabled to
disable this feature.
3
20