Faux Tile; Film Burn/Unburn - High End Systems DML-1200 User Manual

W/axon

Table of Contents

Effect Mode Options Descriptions

5.2.10 Faux Tile

Effect Mode parameter DMX value = 56

This effect divides the image into a grid of tiles with simulated lighting at the edges. The color of the center pixel in each cell

defines the solid color for that tile. You can control the number and spacing of tile, choose between a black and white grid and

adjust color peaking.

Modifier 1: Controls the tile size. The default DMX value of 0 displays a 100 x 100 grid of tiles. Increasing the DMX value decreases

the grid divisions to a minimum of 10 x 10 at a value of 255 (100%).

A small number of larger "tiles" will also result in reduced color variation.

This effect is also available as a Visual Mode adjusted with 2 Modifier parameters, (see Faux Tile on page 76).

Modifier 2: Adjusts the grid spacing and color around each tile. A DMX value of 0 = the minimum black line between tiles. The

spacing increases to a maximum at a DMX value of 127 (49%). At a value of 128 (50%), the space between tiles reverts to the

minimum spacing and turns white. Increasing the value further increases the white spacing to a maximum at a DMX value of 255

(100%).

Modifier 3: Adjusts the color peaking to simulate lighting at the tile edges. A DMX value of 0 = no adjustment and flat color across

the tile. As you increase the DMX value, the peaking increases to a maximum at 255 (100%).

Original content

Effect Mode parameter DMX value = 93

This effect creates multiple burn patterns over the image.

Modifier 1: Adjust the burn-through rate. A DMX value of 65 begins creating a burn pattern with flames from 64 = slowest to 127 =

fasted rate. Values below 65 "unburn the pattern from 63 = slowest to 0 = fastest unburn. Values in the upper half of the range

create the burn pattern without flames from 192 = slowest to 255 = fastest burn rate. A value of 191 "unburns" the patterns from

191 = slowest to 128 = fastest "unburn" without flames.

Modifier 2: Adjusts the amount of film blackening around the burn areas from 0 = the smallest amount of blackening to 255 (100%)

= the largest blackened area.

Modifier 3: Each DMX value selects one of 255 burn patterns.

Original Content

______________________________________________________

Modifier 1 parameter DMX = 188

Modifier 2 parameter DMX = 139

Modifier 3 parameter DMX = 255

Modifier 1 parameter DMX = 152

Modifier 2 parameter DMX = 234

Modifier 3 parameter DMX = 211

Object Effect

DML-1200 w/Axon Embedded Graphic Engine 24/12/2010

Global Effect

Table of Contents