Bulk Dump - Roland V-Bass VB-99 Owner's Manual

Chapter 5 Using MIDI
The table below shows the correspondence between the factory
default Program change Map and the Program Change messages
received when RX PC MAP is set to FIX.
Bank Select Program
Number
0 1
: :
0 128
1 1
: :
2 128
3 1
: :
3 100
* When setting "OMNI MODE" (p. 149) to OFF, be sure to match
"MIDI CH (MIDI Channel)" (p. 149) to the external MIDI device's
transmit channel beforehand.
Setting the MIDI Output Control
Change Number
This sets the Control Change numbers output when the VB-99's
pedals and external pedals or the FC-300's pedals and external
pedals are operated.
1.
Follow Steps 1–3 in "Setting the MIDI-Related
Functions" (p. 52) to display the MIDI screen.
2.
Press PAGE [ ] [
The TX CC screen appears.
3.
Use [F2] (SEL ) or [F3] (SEL
knobs to select the controller you want to set.
4.
Use [F5] or the F5 knob to assign the Control
Change number to be transmitted when the
controller is adjusted.
When the controller selected with F2 or F3 is operated, the
Control Change message selected with F5 is transmitted.
* Control Changes message cannot be output if OFF is selected.
56
Patch
Number
001
:
128
101
:
328
301
:
400
] to display Page 7.
), the F2 or F3

Bulk Dump

With the VB-99, you can use Exclusive messages to set another VB-99
to the same settings or to save effect sound settings to MIDI
sequencers and other such devices.
This transmission of data is referred to as bulk dump.
Data that can be transmitted is described below.
Displayed Data Transmitted
All transmittable data (SYSTEM, GK SETTING,
ALL GLOBAL, PATCH 001–200, FAVORITE SET-
TING)
SYSTEM SYSTEM parameters.
GK SETTING Settings content for GK SETTING
GLOBAL GLOBAL function settings
PATCH Settings for patch numbers 001–200
FAVORITE Settings content in FAVORITE SETTINGS 01–
SETTING 10 for all effects
How to Transmit the Data
When Saving Data to a MIDI Sequencer
Connect the devices as shown below, then place the MIDI sequencer
in standby mode, so it is ready to receive Exclusive messages.
For information on how to operate the sequencer you are
using, refer to the owner's manual that came with it.
MIDI IN
MIDI OUT