Adjusting The Overall Tone (Global Eq); Controlling The Overall Effect Of The Noise Suppressor (Total Ns) - Roland V-Bass VB-99 Owner's Manual

Adjusting the Overall Tone
(GLOBAL EQ)
Both MAIN OUT and SUB OUT feature four-band EQs.
EQ (MAIN) is applied to the output from MAIN OUT;
EQ (SUB) is applied to the output from SUB OUT.
1.
Follow Steps 1–3 in "Selecting the Settings"
(p. 40) to select the SETTING.
2.
Press PAGE [ ] [
3.
Use [F1] – [F6] or the F1 – F6 knobs to adjust
the tone.
Parameter/
Explanation
Range
MAIN EQ (Main Equalizer),
SUB EQ (Sub Equalizer)
A four-band equalizer with high and low ranges is provided.
MAIN EQ SW (Main Equalizer Switch),
SUB EQ SW (Sub Equalizer Switch)
OFF, ON Turns the EQ effect on/off.
TOTAL GAIN
-12–+12dB Adjusts the volume before the equalizer.
LOW GAIN
-12–+12dB Adjusts the low frequency range tone.
HIGH GAIN
-12–+12dB Adjusts the high frequency range tone.
LOW MID FREQ (Low Middle Frequency)
20Hz–10.0kHz Specifies the center of the frequency range that will
be adjusted by the LOW MID GAIN.
LOW MID Q (Low Middle Q)
0.5–16 Adjusts the width of the area affected by the EQ
centered at the LOW MID FREQ.
Higher values will narrow the area.
LOW MID GAIN (Low Middle Gain)
-12–+12dB Adjusts the low-middle frequency range tone.
HIGH MID FREQ (High Middle Frequency)
20Hz–10.0kHz Specifies the center of the frequency range that will be
adjusted by the HIGH MID GAIN.
HIGH MID Q (High Middle Q)
0.5–16 Adjusts the width of the area affected by the EQ
centered at the HIGH MID FREQ.
Higher values will narrow the area.
HIGH MID GAIN (High Middle Gain)
-12–+12dB Adjusts the high-middle frequency range tone.
] to display Page 2–5.
Chapter 3 Global Device Settings (SYSTEM)
Controlling the Overall Effect of
the Noise Suppressor (Total NS)
This controls the overall threshold value for the noise suppressor
settings in the individual patches. This is an effective tool when
basses are changed during performances and for making
adjustments in response to noise levels at the performance venue.
This is an overall setting and does not alter the individual patch
settings.
1.
Follow Steps 1–3 in "Selecting the Settings"
(p. 40) to select the SETTING.
2.
Press PAGE [
3.
Adjust the level with the F1 knob.
This adjusts the noise suppressor threshold levels set in each
patch.
-20 dB – +20 dB
* This adjustment has no effect on patches in which the noise
suppressor is off.
* To use the levels set in the individual patches, set this to 0 dB.
] to display Page 6.
41