Table of Contents
Advertisement
Chapter 8 Parameter Guide
NAME/KEY/BPM
PATCH NAME
Parameter/
Explanation
Range
PATCH NAME
This sets the patch name.
INSERT
Insert a space at the cursor location.
DELETE
Delete a character. The characters that fol-
low get shifted to the left.
SPACE
Input a space at the cursor location.
A0!
Switch between uppercase letters, numbers,
and characters.
A<=>a
Switch between uppercase letters and low-
ercase letters.
CATEGRY
Sets the category for the current patch. Refer
to "Separating Patches into Groups
(CATEGORY)" (p. 85)
CATEGORY
Parameter/
Explanation
Range
CATEGORY
USER 1–10
This selects the Category name.
E.BASS
* You can set USER1–USER10 in
AC BASS
SYNTH
E.GUITAR
EFFECTS
OTHERS
KEY
Parameter/
Explanation
Range
KEY
C (Am)–B (G#m)
This sets the key for the COSM bass and FX
HARMONIST.
The key setting corresponds to the key of the song (#, b) as follows.
142
SYSTEM (p. 86).
BPM
Parameter/
Explanation
Range
BPM
40–250
Adjust the BPM value for each patch.
* BPM (beats per minute) indicates the number of quarter note beats that
occur each minute.
* When "SYNC CLOCK" (p. 149) is set to a value other than
INTERNAL, sending a MIDI clock signal from an external MIDI
instrument synchronizes the VB-99 to the MIDI clock signal that was
sent. To enable the BPM setting, set this to INTERNAL.
* The parameters enabled (SYSTEM BPM, BPM) change according to
the BPM MODE settings.
When they are disabled, the value < > is given.
Control with the BPM
You can tap input the BPM with [F1].
AMP CONTROL
Parameter/
Explanation
Range
FC AMP CTL1, FC AMP CTL2
OFF, ON
This setting switches the FC-300's AMP CTL
1 and AMP CTL 2 parameters on and off.
TX PC (Transmit Program Change)
Parameter/
Explanation
Range
You can assign whatever Program Change numbers you want to
patches.
* This setting is enabled when the SYSTEM MIDI TX PC MAP is set to
PROG (p. 150).
BANK MSB
OFF, 1–127
This sets the Bank Select (MSB) to be output.
BANK LSB
OFF, 1–127
This sets the Bank Select (LSB) to be output.
PC (Program Change)
1–128
This sets the Program Change to be output.
V-BASS LEVEL
Parameter/
Explanation
Range
V-BASS LEVEL
0–200
Adjusts the volume the patch.
* This parameter is the same as V-BASS
LEVEL (p. 131) in MIXER.
MASTER
Advertisement
Table of Contents
