Setting The Operation When Patches Are Switched; Activating The Vb-99'S Tuner From The Fc-300 (Quick Tuner) - Roland V-Bass VB-99 Owner's Manual

Setting the Operation When
Patches Are Switched
This sets the timing at which patches are switched when you press
[ ] [ ] pedals on the FC-300.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to display Page 1.
3.
Press [F5] (FC-300).
4.
Set BANK CHANGE with [F2] (SELECT) or with
the F2 knob.
Available Description
Settings
The patch changes immediately when the FC-300's
IMMEDIATE
[ ] [ ] pedals are pressed.
Even after the FC-300's [
WAIT NUM
pressed, the patch does not change until the NUM-
BER is set.
* The FC-300 will not respond unless you return to the Play screen.
Chapter 4 Using the VB-99 in Combination with an FC-300
] [ ] pedals are
Activating the VB-99's
Tuner from the FC-300
(QUICK TUNER)
You can use the FC-300's number pedals to switch the Tuner
function on and off.
* The Quick Tuner function is enabled only in the Play screen.
* The Quick Tuner function is enabled only when the FC-300's
MODE is set to SYS EX.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to display Page 1.
3.
Press [F5] (FC-300).
4.
Set QUICK TUNER with [F3] (SELECT) or with
the F3 knob.
Available Settings Description
OFF The QUICK TUNER function is not opera-
tional.
ON The QUICK TUNER function is operational.
The TUNER function is alternately switched
on and off each time the currently selected
number pedal is pressed.
47