Speaker Settings; Pre Shape; Gain Sw; Solo Sw - Roland V-Bass VB-99 Owner's Manual

COSM AMP
BASS 360
Parameter/
Explanation
Range
BRIGHT
Turns the bright setting on/off.
OFF Bright is not used.
ON Bright is switched on to create a lighter and
crisper tone.
T.E.
Parameter/
Explanation
Range
MIDDLE FREQ (Middle Frequency)
220Hz, 800Hz, 3.0kHz Specifies the center of the frequency range
that will be adjusted by the MIDDLE.

PRE SHAPE

OFF, 1, 2 This is a shape switch that adds a particular
nuance to the midrange.
SESSION
Parameter/
Explanation
Range
MIDDLE FREQ (Middle Frequency)
220Hz, 800Hz, 3.0kHz Specifies the center of the frequency range
that will be adjusted by the MIDDLE.
ENHANCER
0–100 This controls the clarity and presence of the
sound.
GTR AMP CLEAN / GTR AMP CRUNCH
Parameter/
Explanation
Range
PRESENCE
0–100 Adjusts the tone for the ultra high frequency
range.
BRIGHT
Turns the bright setting on/off.
OFF Bright is not used.
ON Bright is switched on to create a lighter and
crisper tone.

GAIN SW

LOW, MIDDLE, HIGH Provides for selection from three levels of
distortion: LOW, MIDDLE, and HIGH. Dis-
tortion will successively increase for set-
tings of LOW, MIDDLE and HIGH.
* The sound of each Type is created on the basis
that the Gain is set to MIDDLE. So,
normally set it to MIDDLE.

SOLO SW

OFF, ON Switches the tone to one suitable for solos.

SOLO LEVEL

0–100 Adjusts the volume level when the SOLO
SW is ON.
Chapter 8 Parameters Guide
GTR AMP DRIVE / GTR AMP METAL
Parameter/
Explanation
Range
PRESENCE
0–100 Adjusts the tone for the ultra high frequency
range.
GAIN SW
LOW, MIDDLE, HIGH Provides for selection from three levels of
distortion: LOW, MIDDLE, and HIGH. Dis-
tortion will successively increase for set-
tings of LOW, MIDDLE and HIGH.
* The sound of each Type is created on the basis
that the Gain is set to MIDDLE. So,
normally set it to MIDDLE.
SOLO SW
OFF, ON Switches the tone to one suitable for solos.
SOLO LEVEL
0–100 Adjusts the volume level when the SOLO
SW is ON.

Speaker Settings

SUPER FLAT / FLIP TOP / B MAN /
CONCRT 810 / BASS 360 / T.E. /
SESSION / AC BASS
Parameter/
Explanation
Range
SP TYPE (Speaker Type)
Select the speaker type.
OFF This turns off the speaker simulator.
ORIG This is the built-in speaker of the amp you
selected with PREAMP TYPE.
1x15" Models the Trace Elliot 1518.
1X18" Models the SWR Big Ben.
2X15" Models the Acoustic 402.
4X10" Models the SWR Goliath.
8X10" Models the Ampeg 810E.
MIC POS (Mic Position)
This simulates the microphone position.
CENTER Simulates the condition that the micro-
phone is set in the middle of the speaker
cone.
1–10cm Simulates the condition that the micro-
phone is moved away from the center of the
speaker cone.
BOTTOM
0–100 Extracts the low-frequency components of
the sound input to this effect, and adjusts
the amount added to the effect sound.
DIRECT MIX
0–100 Adjusts the volume of the direct sound.
LEVEL
0–100 Adjusts the volume.
129