Treble On; Bass On - Roland V-Bass VB-99 Owner's Manual

COSM BASS
VIOLIN
Parameter/
Explanation
Range
MASTER VOL (Master Volume)
0–100 Sets the overall bass volume level. With a
setting of 0, there will be no sound.
REAR VOL (Rear Volume)
0–100 Sets the volume of the rear pickup. With a
setting of 0, there will be no sound.
FRONT VOL (Front Volume)
0–100 Sets the volume of the front pickup. With a
setting of 0, there will be no sound.

TREBLE ON

OFF, ON Switches the rear pickup on/off.

BASS ON

OFF, ON Switches the front pickup on/off.
RHYTHM/SOLO
RHYTHM The volume will be set to 50.
SOLO The volume will be set to 100.
VARI
Parameter/
Explanation
Range
CTL TYPE (Control Type)
2V2T Two volume and two tone controllers.
2V1T Two volume and one tone controller.
BAL One balance and one tone controller.
2BAND Bass and treble controllers.
MASTER VOL (Master Volume) *1
0–100 Sets the overall bass volume level. With a
setting of 0, there will be no sound.
VOL (Volume) *2
0–100 Sets the overall bass volume level. With a
setting of 0, there will be no sound.
REAR VOL (Rear Volume) *1
0–100 Sets the volume of the rear pickup. With a
setting of 0, there will be no sound.
FRONT VOL (Front Volume) *1
0–100 Sets the volume of the front pickup. With a
setting of 0, there will be no sound.
BAL (Balance) *2
R100:0F–R0:100F Adjusts the volume balance of the rear pick-
up and front pickup.
REAR TONE *3
-50–+50 Adjusts the tone of the rear pickup.
FRONT TONE *3
-50–+50 Adjusts the tone of the front pickup.
TONE *4
-50–+50 Adjusts the tone of the pickup.
TREBLE *5
-50–+50 Adjusts the tone for the high frequency
range.
Chapter 8 Parameters Guide
Parameter/
Explanation
Range
BASS *5
-50–+50 Adjusts the tone for the low frequency
range.
REAR PU (Rear Pickup),
FRONT PU (Front Pickup)
TYPE
Specify the type of pickup.
SINGLE A single-coil pickup.
DOUBLE A double-coil pickup.
PIEZO A piezo pickup.
POS (Position)
5–450mm Specifies the location of the pickup in terms
of the distance from the bridge. Higher set-
tings will simulate a greater distance be-
tween the pickup and bridge.
* It is not possible to set the position if
"PIEZO" is selected as the pickup type.
PHASE
Specify the phase of the pickup when mixing the front and rear pick-
ups.
IN The pickup will be mixed in normal phase.
OUT The pickup will be mixed in reverse phase.
OFFSET
-445–+445mm Finely adjust the rear pickup position for
each string.
* It is not possible to set the offset if "PIEZO"
is selected as the pickup type.
*1 Setting available with CTL TYPE set to 2V2T or 2V1T.
*2 Setting available with CTL TYPE set to BAL or 2BAND.
*3 Setting available with CTL TYPE set to 2V2T.
*4 Setting available with CTL TYPE set to 2V1T or BAL.
*5 Setting available with CTL TYPE set to 2BAND.
99