Setting The Device (Amp) Connected To Main Out (Output Select); Inputting The Divided Pickup Settings (Gk Settings) - Roland V-Bass VB-99 Owner's Manual

Setting the Device (Amp)
Connected to MAIN OUT (Output
Select)
Use this procedure to set the type of device connected to the MAIN
OUT jacks.
fig.01-071
3
3
1.
Press [GLOBAL].
The Global screen is displayed.
fig.01-072d
2.
Press PAGE [ ] to go to Page 1.
3.
Press [F4] (SELECT) or turn the F4 knob to set
the type of device to be connected to the MAIN
OUT jacks.
Value Explanation
Use this setting when connecting to a tweet-
AMP WITH TWEETER
er-equipped bass amp.
Use this setting when connecting to a bass
AMP NO TWEETER amp that has no tweeter. The high-frequen-
cy range is adjusted.
Use this setting when using headphones or
LINE/PHONES connecting directly to a PA system or multi-
track recorder.
4.
Press [EXIT] to return to the Play screen.
4
2
1
Chapter 1 Outputting Sounds
Inputting the Divided Pickup
Settings (GK Settings)
The VB-99's sound characteristics vary greatly depending on how
the divided pickup is installed. To ensure consistent conditions for
optimal sound production, be sure to make the settings affecting the
divided pickup (the GK settings). With these settings appropriately
made, the VB-99 can then operate under optimal conditions.
* For information on parameters not described in this chapter, refer to
"GK SETTING" (p. 145).
When using more than one bass with the VB-99, you can
save the settings for each bass separately.
The GK settings are extremely important to getting
good tones from the VB-99. Be sure to input the
settings correctly.
fig.01-100
8 10 11
5 6 3
1.
Press [SYSTEM].
The System screen is displayed
2.
Press PAGE [ ] to go to Page 1.
3.
Press [F3] (GK).
The GK Settings screen is displayed.
fig.01-060d
4.
Press PAGE [ ] [
12
2 4 7 9
1
] to go to Page 2.
21