To Perform A Functional Check - Rigol DS1000E Series User Manual

RIGOL

To Perform a Functional Check

Perform this quick functional check to verify that the instrument is operating
correctly.
1. Turn on the instrument.
Use the power cord designed for the oscilloscope only.

The power requirements are 100 to 240 VAC

Turn on the instruments, and wait until the display shows the waveform window.

Press the Storage button, select Storage in the menu. Rotate the multiple

function knob to select Factory and press the knob down. Then, press Load .
Power button
WARNING:
!
To avoid electric shock, be sure the oscilloscope is properly grounded.
2. Input a signal to a channel of the oscilloscope
DS1000E series: 2 channels input + 1 external trigger channel input
DS1000D series: 2 channels input + 1 external trigger channel input +16 channels
digital input
Do the following steps:
① Set the switch on the probe to 10X and connect the probe to Channel1 on the
oscilloscope:
1-8
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Figure 1- 9
Turn on and Check the instrument
User's Guide for DS1000E, DS1000D Series
, 45Hz to 440Hz.
RMS
Storage button
© 2008 RIGOL Technologies, Inc.