Entering Parameter Ids - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

1.5

Entering Parameter IDs

Throughout this manual, a four digit number inside of parentheses, for example (9403),
indicates a parameter ID number that can be entered using one of the following methods:
● the keypad located on the front of the drive
● the ToolSuite, a PC-based application software package (refer to the
Manual for more information).
Use the following procedure to enter a parameter ID:
1. Press [SHIFT] + [→]. You do not need to hold down the [SHIFT] key while you press the [→]
key.
2. Enter the ID number.
Note
Refer to the
operation and entering parameter ID numbers.
NXGpro Communication
Function Manual, AB, A5E33486415A
NXGpro Control Operating Manual for complete information on keypad
Introduction
1.5 Entering Parameter IDs
NXGpro ToolSuite
23