Communication Overview - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

Nxgpro communication medium-voltage variable frequency drive
Hide thumbs Also See for SINAMICS PERFECT HARMONY GH180:
Table of Contents

Advertisement

Introduction

1.1 Communication Overview

1.1
Communication Overview
Each NXGpro Control System has two communication connectors that enable network
communication through a variety of communication protocols. The system supports up to two
networks.
The NXGpro Control is shipped with the necessary hardware to support Modbus™ Ethernet
network protocol connectivity. The Modbus™ Ethernet protocol does not require the addition
of an Anybus™ module.
Connectivity using other network protocols is possible with optional controller cards, called
Anybus™ modules, which plug into the fiber optic board.
Anybus™ modules are available from Siemens and support the following protocols:
● Modbus™ Ethernet
● Profibus™
● ProfiDrive™
● DeviceNet™ (Profile 12)
● ControlNet™
● Ethernet /IP
In addition to Anybus™ modules, the Modbus™ protocol is also supported.
Note
Display the type of Anybus™ modules installed in the system using parameter 'Network Module
Type' (9955).
This information may be needed to verify you have the correct module for the network interface
to be implemented.
The following figure shows the NXGpro Control and includes the locations of the connectors
for the Anybus™ modules (network 1 and 2).
18
NXGpro Communication
Function Manual, AB, A5E33486415A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents