Remote Capabilities - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

Introduction

1.2 Remote Capabilities

1.2 Remote Capabilities
The communication interface to the drive allows remote control and monitoring of the drive.
Control of the drive can be achieved through registers or telegrams that are sent to the drive,
working in conjunction with the system program (SOP).
This allows for a range of control capabilities including:
● run request
● stop request
● fault reset
● stop
● reverse speed demand.
There are 128 remote user-programmable software flags that can be monitored and/or set
through the SOP:
● 64 programmable inputs
● 64 programmable outputs
Where applicable, refer to the
information.
Note
Discrete controls and user-defined control/feedback flags are configured through the drive's
built-in SOP that is provided with each drive.
20
Software Programming Section of a chapter for further
NXGpro Communication
Function Manual, AB, A5E33486415A