Siemens SINAMICS PERFECT HARMONY GH180 Function Manual page 29

Potential Arc Hazard
● Arcing can result in damage to property, serious injury and even death.
● The equipment has not been tested and rated for arc flash protection.
● Avoiding arc hazard risks is dependent upon proper installation and maintenance.
● Incorrectly applied equipment, incorrectly selected, connected or unconnected cables, or
● Follow all applicable precautionary rules and guidelines as used in working with medium
● The equipment may be used only:
Additional safety precautions and warnings appear throughout this manual. These important
messages should be followed to reduce the risk of personal injury or equipment damage.
Obey Rules to Avoid Risk of Death
● Always comply with local codes and requirements if disposal of failed components is
● Always ensure the use of an even and flat truck bed to transport the VFD system. Before
● Always confirm proper tonnage ratings of cranes, cables, and hooks when lifting the VFD
● Never disconnect control power while medium voltage is energized. This could cause
● Never store flammable material in, on, or near the drive enclosure. This includes
● Never use fork trucks to lift cabinets that are not equipped with lifting tubes. Be sure that
NXGpro Communication
Function Manual, AB, A5E33486415A
WARNING
the presence of foreign materials can cause arcing in the equipment.
voltage equipment.
– for the applications defined as suitable in the technical description.
– in combination with equipment and components supplied by other manufacturers which
have been approved and recommended by Siemens.
WARNING
necessary (for example, CPU battery, capacitors, etc.).
unloading, be sure that the concrete pad is level for storage and permanent positioning.
system. Dropping the cabinet or lowering it too quickly could damage the unit.
severe system overheating and/or damage.
equipment drawings and manuals.
the fork truck tines fit the lifting tubes properly and are the appropriate length.
2.4 Safety Information and Warnings
Safety notes
29