Table 9-19 Data To Drive Pick List Variables - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

ControlNet Communication
9.3 Parameter Assignment/Addressing
Table 9-19 Data to Drive Pick List Variables
Name
None
Fixed Reg Bits
Velocity Demand
Auxiliary Demand
Net Input Flag 1
Net Input Flag 2
Net Input Flag 3
Net Input Flag 4
Ratio
Forward Max Lim
Reverse Max Lim
232
Unit Scaling
None None
None None
Hz /10
RPM 1
% /10
Hz /10
RPM 1
% /10
None None
None None
None None
None None
% % / 100
% / 10000 or
% / 100
% / 10000 or
% / 100
16 Bit Data Notes
Type
None None
Bit Field When parameter 'Net Control Type' (9945) is set
to 'SOP' the bits will be used in the SOP to control
drive functions.
When parameter 'Net Control Type' (9945) is set
to 'Fixed' the bits will be defined as follows in the
control software.
● Bit 0: Run Forward
● Bit 1: Run Reverse
● Bit 2: Fault Reset
● Bit 3: Stop
● Bit 4: Reserved
● Bit 5: Start/Stop Control From Network
● Bit 6: Speed Command From Network
● Bit 7 - 15: Reserved for future assignment
Signed Speed Demand
Signed Auxilary Speed Demand
Bit Field Network 1 SOP flags:
Network1Flag0_I ~ Network1Flag15_I
Network 2 SOP flags:
Network2Flag0_I ~ Network2Flag15_I
Bit Field Network 1 SOP flags:
Network1Flag16_I ~ Network1Flag31_I
Network 2 SOP flags:
Network2Flag16_I ~ Network2Flag31_I
Bit Field Network 1 SOP flags:
Network1Flag32_I ~ Network1Flag47_I
Network 2 SOP flags:
Network2Flag32_I ~ Network2Flag47_I
Bit Field Network 1 SOP flags:
Network1Flag48_I ~ Network1Flag63_I
Network 2 SOP flags:
Network2Flag48_I ~ Network2Flag63_I
Signed
Unsigned
Unsigned
NXGpro Communication
Function Manual, AB, A5E33486415A