Installing The Autosampler - Agilent Technologies G1313A Reference Manual

Preparation
Parts required
WA R NI NG
Figure 5
Safety cover
Safety flap
1 Install the LAN interface board in the sampler (if required), see "Agilent
2 Remove the adhesive tape which covers the front door.
3 Remove the front door and remove the transport protection foam.
4 Place the Autosampler on the bench or in the stack as recommended in

Installing the Autosampler

Installing the Autosampler
Installing the Autosampler
Locate bench space
Provide power connection
Unpack the Sampler
Sampler
Power cord, for the other cables see below and "Cable Overview" on page 185
Chemstation and/or Control Module G1323B.
To avoid personal injury, keep fingers away from the needle area during
autosampler operation. Do not bend the safety flap away from its
position, or attempt to remove the safety cover (see Figure 5). Do not
attempt to insert or remove a vial from the gripper when the gripper is
positioned below the needle.
Safety Flap
1100 Series Interface Board to general purposes" on page 198.
"Recommended Stack Configuration for an Autosampler (Front View)" on
page 22.
26