Sa Adjust Sensor U - Citizen CL-S400DT Technical Manual

Notes on reassembling:
• Before assembling the "Lever R Cover Lock", turn it
clockwise and inset its end into the slit of the frame.
(Refer to the above enlarged view.)
• Note that the "Spring Cover Open Knob" is free. It is
simply supported by the "Knob Cover Open" and the
frame.
• Turn over the "Lever R Cover Lock" and apply grease to
the places marked with " ".
Lever R Cover Lock (6 places): FLOIL G-311S

3-6-11. SA Adjust Sensor U

1. Remove the "SA Cover". Refer to
2. Remove the "Case" from the main body. Refer to
3. Disconnect the "SA Mechanism Frame" from the "SA2 Base Frame". Refer to
Disconnecting "SA Mechanism Frame" from "SA2 Base
4. Disassemble the "SA Mechanism Frame". Refer to
Frame"".
5. Remove 2 "E-Ring, 2" and detach the "Shaft Roller" and 2 "Roller Guide Paper U".
6. Peel off the "Sheet Adjust Sensor U", "Label, Heat Caution-02" and "Sheet Head Insulation".
7. Remove 2 screws (BHT (PT), M2.6x5) and detach the "Cover Adjust Sensor U".
8. Lift the "SA Adjust Sensor U" block from the "Guide Paper U" to remove it.
9. Remove the "Pawl Adjust Sensor U" from the "SA Adjust Sensor U" block.
10. Remove 1 screw (NO.0 PHT (BT#1), M2x3) and detach the "SA Adjust Sensor U" from the
"Holder Adjust Sensor U".
Hook
Slits
SA Adjust Sensor U
NO.0 PHT (BT#1), M2x3
E-Ring, 2
Guide Paper U
Sheet Head Insulation
Sheet Adjust Sensor U
Lever R Cover Lock
"3-6-2 SA Cover and SA LCD
"3-6-3
"3-6-7 Disassembly of "SA Mechanism
BHT (PT), M2.6x5
Cover Adjust Sensor U
Pawl Adjust Sensor U
Holder Adjust Sensor U
Label, Heat Caution-02
3-21
Chapter 3 Disassembly and Maintenance
3-6 Disassembly, Reassembly and Lubrication
(FLOIL G-311S)
[Viewed from the rear side]
PCB".
Case".
Frame"".
Shaft Roller
Roller Guide Paper U
E-Ring, 2
"3-6-4
CL-S400DT