Test Mode; Self Print Mode - Citizen CL-S400DT Technical Manual

Chapter 2 Operating Principles
2-3. Operation Panel

2-3-2. Test mode

The following Test modes are available:
Operation
[FEED] + "Power ON"
[STOP] + "Power ON"
[MENU] + "Power ON"

(1) Self print mode

You can check the printing quality by printing the built-in self print pattern.
This function is convenient to obtain optimum printing while adjusting the media thickness with
the Media thickness adjustment dial and media width with the Media width adjustment dial.
For label (prints 2 labels):
1. While pressing and holding the [FEED] key, turn on
the power.
2. Wait until the POWER LED (green) turns on and the
LCD indicates "Self Print Mode" "Label Media", and
then release the [FEED] key.
The printer enters self print mode and the label is fed.
Self test printing is made for two labels, and then
printing stops.
3. To repeat self test printing, press the [FEED] key
again.
To exit from self print mode: Turn off the power.
For continuous media:
1. While pressing and holding the [FEED] key, turn on
the power.
2. Wait until the POWER LED (green) turns on and the
LCD changes from "Self Print Mode" "Label Media" to
"Self Print Mode" "Cont. Media", and then release the
[FEED] key.
The printer enters self print mode for self test printing
and then stops after printing.
3. To repeat self test printing, press the [FEED] key again.
To exit from self print mode: Turn off the power.
CL-S400DT
Description
Enters self print mode.
Enters hex dump mode.
Enters menu list printing mode.
2-30
[Print pattern in self print mode]
Media feed direction