Sa Adjust Sensor L - Citizen CL-S400DT Technical Manual

3-6-9. SA Adjust Sensor L

1. Remove the "SA Cover". Refer to
2. Remove the "Case" from the main body. Refer to
3. Disconnect the "SA Mechanism Frame" from the "SA2 Base Frame". Refer to
Disconnecting "SA Mechanism Frame" from "SA2 Base
4. Disassemble the "SA Mechanism Frame". Refer to
Frame"".
5. Removal of the "SA Guide Paper L"():
1) Remove 2 screws (BH (N), M3x6 (NI))().
2) Unhook the claws (rear side: 5 place, left side: 1 place) of the "SA Guide Paper L"() and
remove the "SA Guide Paper L" upward after sliding it to the right.
6. Removal of the "SA Head Up SW"():
1) Remove 1 screw (BHT (PT), M3x6) and detach the "Holder Cover Open SW"().
2) Remove 1 screw (NO.0, PHT (BT #3), M1.7x7) and detach the "SA Head Up SW"().
Sheet Adjust Sensor L
Holder Adjust Sensor L
10
SA Adjust Sensor L
9
8 Holder Adjust Sensor L Cable
5
Lever Adjust Sensor L
SA2 Main Frame
"3-6-2 SA Cover and SA LCD
Key Adjust Sensor L
Spring Adjust Sensor L
14
Label, Edge
Caution-02
BHT (PT),
M2x5
3-17
Chapter 3 Disassembly and Maintenance
3-6 Disassembly, Reassembly and Lubrication
PCB".
"3-6-3 Case".
Frame"".
"3-6-7 Disassembly of "SA Mechanism
6
7
Sheet Adjust
Sensor L Scale
SA Guide Paper L
Guide Paper R
12
BH (N), M3x6
(NI)
1
Guide Paper L
Spring Leaf Guide
Paper R
NO.0 PHT (BT#1), M2x3
NO.0, PHT (PT, BK), M2x5
NO.0 PHT (BT #3), M1.7x7
SA Head Up SW
Holder Cover Open SW
BHT (PT), M3x6
"3-6-4
13
2
15
11
4
3
CL-S400DT