Chapter 3 Disassembly and Maintenance
3-6 Disassembly, Reassembly and Lubrication
Notes on reassembling:
• The places to stick the "Leg, Case LF" are indicated on the frame. Be sure to stick them to the
original places.
• Be sure to securely engage the "Stopper Guide Paper U" (gray) with the frame.
• Do not mix up springs. The diameter and length of the "Spring Head L" and "Spring Head R"
differ as follows.
Spring Head L
• Assemble the "Spring Head R" in the convexed fringe of the "Plate Adjust Spring Holder" and the
"Spring Head L" in the convexed fringe of the "SA Cover Frame" as shown below.
• Assemble the "Spacer Adjust Head Angle" so that its protruding side faces the "Cam Adjust Head
Angle".
• Apply grease to the following places.
Cam part of the "Cam Adjust Head Spring" and the "Cam Adjust Head Angle": FLOIL G-311S
Cam Adjust Head Spring
(FLOIL G-311S)
• Tighten the "SA Head Cable" with a new "Wire Tie" as it was.
CL-S400DT
Spring Head R
Spring Head R
Spring Head L
Cam Adjust Head Angle
Spacer Adjust Head Angle
Protrusion
Cam Adjuste Head Angle
(FLOIL G-311S)
3-26