Steering/Wheel Bearings; Steering Bearings Inspection - Triumph Speed 400 Owner's Handbook Manual

NOTICE
Use an open ended
counter-hold the mirror boss as the
mirror lock nut is loosened/tightened.
Failure to counter-hold the boss will
cause damage to the thread and the
mirror to become loose.
Counter-hold the mirror boss and
▼
loosen the mirror lock nut.
Position the mirror arm to give rear
▼
visibility in the riding position and
tighten the lock nut by hand.
Counter-hold the mirror boss and
▼
tighten the mirror lock nut to
16.6 lbf ft (22.5 Nm).
Slide the rubber cover over the lock
▼
nut.
4
cleu
1. Mirror arm (Scrambler 400 X shown)
2. Lock nut
3. Mirror boss
4. Rubber cover
MAINTENANCE AND ADJUSTMENT

Steering/Wheel Bearings

spanner to
To
the motorcycle falling during the
inspection,
motorcycle is stabilized and secured
on a suitable support.
When inspecting steering and wheel
bearings, do not exert extreme force
against each wheel or rock each wheel
vigorously as this may cause the
motorcycle to become unstable and
fall from its support.
Failure to follow the advice above
could result in motorcycle damage,
serious injury or death.

Steering Bearings Inspection

1
Make sure the motorcycle is stabilized
and adequately supported.
2
Do not support the motorcycle on
3 any ancillary component, the exhaust
system or any other non structural
parts of the motorcycle frame.
A correctly supported motorcycle will
help prevent it from falling.
An
resulting
serious injury or death.
WARNING
prevent risk of
make sure
WARNING
unstable motorcycle
in motorcycle
115
injury from
that the
may fall
damage,