Microscan MS-3 Manual Book page 69

Chapter
5
Autodiscriminate ..........................................................................................5-4
Narrow Margins ...........................................................................................5-5
Symbology ID ..............................................................................................5-6
Background Color........................................................................................5-7
Code 39 .......................................................................................................5-8
Codabar.....................................................................................................5-11
Interleaved 2 of 5.......................................................................................5-14
UPC/EAN ..................................................................................................5-17
Code 128 ...................................................................................................5-20
UCC/EAN-128 ...........................................................................................5-21
Code 93 .....................................................................................................5-24
Pharmacode ..............................................................................................5-25
This section describes the various symbol types that can be read and decoded by the
scanner.
Code 39 is enabled by default. To enable all codes, send a
the scanner from the Terminal window.
See http://www.aimusa.org/standards/aimpubs.htm
about symbologies.
Note: The characters NULL <>
not through ESP or serial commands.
Note: You can learn the current setting of any parameter by inserting a question
mark after the number, as in <K100?>
1. If using an I 2/5 symbol, verify that the number of characters in the symbol being scanned
matches the code length enabled for the I 2/5 symbol type (default is 10 and 6).
MS-3 Laser Scanner User's Manual
Symbology
Chapter Contents
<P>
1
for additional information
and , can only be entered through embedded menus,
To see all "K" commands, send <K?>.
serial command to
5-1