Microscan MS-3 Manual Book page 145

Chapter Chapter
10 10
Warning Message Status ...................................................................... 10-5
Laser High Warning............................................................................... 10-6
Laser Low Warning ............................................................................... 10-7
NOVRAM Corrupt Warning Status ........................................................ 10-8
Power-on Count .................................................................................... 10-9
Time Since Last Reset ........................................................................ 10-10
This section describes warning and operating messages and their settings.
Important: Since Warning Messages and NOVRAM Messages are not enabled by
default, these messages will not be displayed. However, if you suspect that erroneous
defaults are occurring, enable Warning Messages and NOVRAM Messages by
sending <K"400,1,,,1>.
Note: The characters NULL <>
not through ESP or serial commands.
Note: You can learn the current setting of any parameter by inserting a question
mark after the number, as in <K100?>
MS-3 Laser Scanner User's Manual
Diagnostics
Chapter Contents
and , can only be entered through embedded menus,
To see all "K" commands, send <K?>.
10-1