Serial Trigger Character - Microscan MS-3 Manual Book

Chapter 4

Serial Trigger Character

Definition: A single ASCII host serial trigger character that initiates the read cycle.
Serial Trigger Character is considered an on-line host command and
requires the same command format as all host commands: that is, to
be entered within angle brackets delimiters
Usage: Allows the user to define the trigger character that initiates the read
cycle.
Serial Trigger Character (delimited)
Definition: A delimited trigger character is one that either starts or ends the read
cycle and is enclosed by delimiters such as < >.
Usage: Allows the user to define the trigger character that initiates the read
cycle.
Serial Cmd: <K201, serial trigger
Default: ^] (corresponds to <GS> displayed in the embedded menu)
Options: Any single ASCII character, including control characters, except NUL
(00H), an existing host command character, or an on-line protocol char-
acter. Control characters entered on the command line are displayed in
the menu as mnemonic characters.
Note: Serial Data or Serial Data or Edge triggering mode must be enabled for
Serial Trigger Character to take effect.
MS-3 Laser Scanner User's Manual
Read Cycle/Trigger
< >.
character>
4-11