Table 11-1 Summary Of Utility Serial Commands - Microscan MS-3 Manual Book

Utilities by Serial Command

Table 11-1 Summary of Utility Serial Commands

Command Type Command
<N>
<O>
<T>
Counter Request
<U>
and Clear
<V>
<W>
<X>
<Y>
<!>
<!b>
Part Number/ <!a>
Checksum
<#>
<#b>
<#a>
Read Rate <Cp>
<C>
<Cm>
<Cs>
<J>
<H>
<I>
<KE>
Device Control
<KF>
<L1>
<L2>
<L3>
<P>
<Q>
Code Types
<R>
<S>
Trigger <char>
<A>
<Ard>
<Arp>
Default/Reset/Save
<Arc>
<Z>
<Zc>
MS-3 Laser Scanner User's Manual
11-2
Name
Noread Counter
Noread Counter Reset
Trigger Counter
Trigger Counter Reset
Good Read/Match Counter
Good Read/Match Counter Reset
Mismatch Counter
Mismatch Counter Reset
Display Checksums of EPROM Flash memory
Display Checksum for Boot Code
Display Checksum for Application Code
Display Part Numbers
Display Boot Code Part Number
Display Application Code Part Number
Enter Single Symbol Percent Rate Test
Enter Single Symbol Decode Rate Test
Enter Multisymbol Percentage Rate Test
Enter Multisymbol Decode Rate Test
Exit Decode Rate and Percent Rate Test
Enable Laser Scanning
Disable Laser Scanning
Motor On
Motor Off
Programmable Output 1
Programmable Output 2
Programmable Output 3
Autodiscriminate All Codes
Enable Code 39 Only
Enable Codabar Only
Enable I 2/5 Only
Serial Trigger Character
Reset (does not save for power-on)
Reset and recall factory defaults
Reset and recall power-on parameters
Recall and recall customer default parameters
Save current settings for power-on
Save current settings as customer default parameters